Allied Telesis AT-9000/28 - Show Auth-Mac Statistics Interface

AT-9000 Switch Command Line User’s Guide
Section VIII: Port Security 779
SHOW AUTH-MAC STATISTICS INTERFACE
Syntax
show auth-mac statistics interface port
Parameters
port Specifies a port. You can enter more than one port.
Mode
Privileged Exec mode
Description
Use this command to display EAP packet statistics of authenticator ports.
This command is equivalent to “SHOW DOT1X STATISTICS INTERFACE
Command” on page 784.An example is shown in Figure 128.
Figure 128. SHOW AUTH-MAC STATISTICS INTERFACE Command
Example
awplus# show auth-mac statistics interface port1.0.7
Authentication Statistics for interface port1.0.2
EAPOL Frames Rx: 0 - EAPOL Frames Tx: 0
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 0 - EAP Response Frames Rx: 0
EAP Req/Id Frames Tx: 0 - EAP Request Frames Tx: 0
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 0 - EAPOL Last Frame Src: 0000.0000.0000