Allied Telesis AT-9000/28 - Lldp Notification-Interval

Chapter 62: LLDP and LLDP-MED Commands
924 Section X: Network Management
LLDP NOTIFICATION-INTERVAL
Syntax
lldp notification-interval value
Parameters
value Specifies the notification interval. The range is 5 to
3600 seconds.
Mode
Global Configuration mode
Description
Use this command to set the notification interval. This is the minimum
interval between LLDP SNMP notifications (traps).
Confirmation Command
“SHOW LLDP” on page 949
Example
This example sets the notification interval to 35 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# lldp notification-interval 35