Chapter 6: Basic Switch Management Commands
136 Section II: Basic Operations
SNMP-SERVER LOCATION
Syntax
snmp-server location
location
Parameters
location Specifies the location of the switch. The location can
be up to 39 alphanumeric characters. Spaces and
special characters are allowed.
Mode
Global Configuration mode
Description
Use this command to add location information to the switch.
To remove the current location information without adding new
information, use the NO form of this command.
Confirmation Command
“SHOW SYSTEM” on page 132
Examples
This example adds the location “Bldg5_fl2_rm201a” to the switch:
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server location Bldg5_fl2_rm201a
This example removes the current location information:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server location
To Next Page
Loading...
