Chapter 18: Port Mirror Commands
308 Section II: Basic Operations
SHOW MIRROR
Syntax
show mirror
Parameters
None.
Modes
User Exec mode and Privileged Exec mode
Description
Use this command to display the source and destination ports of the port
mirror on the switch. An example is shown in Figure 65.
Figure 65. SHOW MIRROR Command
The fields are described in Table 25.
Port Mirroring:
Mirroring State ..................... Enabled
Mirror-To (Destination) Port ........ 22
Ingress (Rx) Mirror (Source) Ports .. 1,3
Egress (Tx) Mirror (Source) Ports ... 1,3,11-13
Table 25. SHOW MIRROR Command
Parameter Description
Mirror Test Port Name The destination port of the port mirror.
The port mirror can have only one
destination port.
Mirror-To (Destination)
Port
The destination port of the port mirror.
Ingress (Rx) Mirror
(Source) Port
Source ports of the port mirror. The
ingress traffic on the ports is copied to the
destination port.
Egress (Tx) Mirror
(Source) Port
Source ports of the port mirror. The
egress traffic on the ports is copied to the
destination port.
To Next Page
Loading...
