Allied Telesis AT-9000/28 - Show Dot1 X Statistics Interface

Chapter 55: 802.1x Port-based Network Access Control Commands
784 Section VIII: Port Security
SHOW DOT1X STATISTICS INTERFACE
Syntax
show dot1x statistics interface port
Parameters
port Specifies a port. You can enter more than one port.
Mode
Privileged Exec mode
Description
Use this command to display EAP packet statistics of authenticator ports.
This command is equivalent to “SHOW AUTH-MAC STATISTICS
INTERFACE” on page 779. An example is shown in Figure 133.
Figure 133. SHOW DOT1X STATISTICS INTERFACE Command
Example
awplus# show dot1x statistics interface port1.0.7
Authentication Statistics for interface port1.0.2
EAPOL Frames Rx: 0 - EAPOL Frames Tx: 0
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 0 - EAP Response Frames Rx: 0
EAP Req/Id Frames Tx: 0 - EAP Request Frames Tx: 0
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 0 - EAPOL Last Frame Src: 0000.0000.0000