Branson 2000Xc - Page 290

100-412-234 REV. 06 277
D.2.20 Get Users
Once the number of Users is known via the Get Number of Users request, then this service
can be properly called. Since there are internal limitations to data bandwidth, only a
maximum of 50 Users can be requested at any given time. There are two ways of getting
the User information.
1. Get the most recent 50 Users. This is accomplished by setting both the “From” and “To” values to
0
2. Get any random chunk of up to 50 consecutive Users. E.g. User # 120-169
In the POST data request there are two additional fields required along with the SID.
These are the “From” and “To” values. These fields are how the specific User #s are
requested. The difference between these values cannot exceed 50.
URL
http://<2000Xc IP Address>/Services/GetUsers
POST Data
{"Sid":12345,"From":120,"To":169}
Successful Response
{“ErrorCode”:0,
“UserDetails”:[
{“1”:Value,“2”:Value,…,”7”:Value},
{“1”:Value,“2”:Value,…,”7”:Value},
…
{“1”:Value,“2”:Value,…,”7”:Value}]}
See UserID Table IDs for the lookup table of IDs in the Table D.6.