278 100-412-234 REV. 06
D.2.21 Create/Update User
Creating and Updating Users are two separate web requests, but they are grouped
together here because they have the same POST data and very similar requirements.
There are minor differences when it comes to error codes as a response, but they are
described in Table D.1.
User Level is key when dealing with creating or updating user data. Only certain levels of
authority can manage this and therefore the appropriate user must be logged in through
web services to successfully complete these requests.
There is no method of deleting a User. Users must always remain in the power supply and
therefore can either be activated or deactivated. This is referred to as the “Status” value
that is sent with this request. It can be either 0 or 1 for inactive or active respectively.
There are a maximum of 1000 total users allowed in the power supply and a maximum of
500 active users at any given time. Any attempt to add additional users will result in an
error as well as any attempt to modify a particular user to be active that causes the
threshold to be exceeded will also result in an error.
The new User or updated user information must follow the password guidelines.
URL-Create
http://<2000Xc IP Address>/Services/SetUser
URL-Update
http://<2000Xc IP Address>/Services/UpdateUser
POST Data
{"Sid":12345,"UserId":"User1","Password":"Def@1234","UserLevel":1,"Status"
:1,"PassExpTime":20,"Reason":"John Left Company"}
Successful Response
{“ErrorCode”:0}
Password Expire Time is in minutes.
The lookup table for User Level IDs can be found in the Table D.7.
To Next Page
Loading...
