Canberra Lynx - Launching the Scope

5. The Mixed Signal Oscilloscope
Accessible via the Web-based control interface, Lynx's built-in digital storage oscillo
-
scope (DSO) can simultaneously display up to eight digital signals and any one of six
analog signals. This allows examination of the digitally-shaped signal reconstructed in
time to assist in adjusting and verifying instrument setup, pole zero optimization and
manual Reset Preamp Inhibit adjustments.
The oscilloscope captures data digitally within the FPGA. No calibration is required.
Launching the Scope
Choose Digital Oscilloscope from the Lynx Menu's MCA Settings command
group to launch Lynx's built-in oscilloscope in a new instance of your web browser.
You might be prompted to press 'Enter' or 'spacebar' to begin.
140 Lynx™ Digital Signal Analyzer
Figure 106 - Example of Lynx's Mixed Signal Oscilloscope display