Defining an MCA
This section discusses setting up a Lynx-based MCA, which has a fully programmable
front end, and saving that configuration as a MID file.
Functions such as its DSP Gain, DSP Filter, Digital Stabilizer, MCS and High Voltage
Power Supply are all controlled from the host computer rather than using the other
Lynx controls or features.
To begin, select the Lynx MCA entry in the Definition Table that you wish to set up.
Device Setup
The Devices menu sets the parameters for the Lynx’s MCA and associated devices.
7.
Select the MCA option from the Devices menu.
Some Devices options in the menu list are disabled (grayed out) because they do not
have any settable parameters. Of the enabled Devices, only the MCA and Sample
Changer have user-selectable parameters. The remainder default to their only parame
-
ter: Internal.
MCA Input Definition (MID) Editor
User’s Manual 29
Figure 20 - MID definition for the Lynx MCA
To Next Page
Loading...