Format
This defines the storage format of the acquisition file(s) to be saved.
–
CAM will store data to a CAM file.
–
N42 will store data to an ANSI N42.42 file.
–
Both will result in both files.
Store Audit Logs
This will cause the current Audit Log to be stored.
Note
Additional controls for the Audit Logs are found under the separate Mainte
-
nance | Audit Logs heading.
Media State
This displays the current storage media that is installed in the Lynx.
Transfer Files
If a formatted USB flash memory stick is installed (connected to USB H connector,
and recognized by the Lynx) then this group is displayed. Subsequent data storage will
be performed using this media. Data files may be transferred from internal non-volatile
memory storage to the USB memory stick by pressing the Start button.
Status
Displays the transfer status (completed, or an error message)
Delete files after transfer complete
Enabling this feature will result in deletion of files on the Lynx after they have been
successfully transferred to the USB memory stick.
Start
Starts the file transfer process. Status is shown in real time in the Status field.
Stop
Aborts the file transfer process.
Miscellaneous
This displays read-only attributes of this Lynx device.
•
Serial Number - the serial number for this Lynx.
•
Version information - the versions of the Firmware installed; the FPGA; and
the Driver.
User’s Manual 127
System | Stop Setup
To Next Page
Loading...