•
Enter your User name and Password (not case sensitive) and click Login.
If not yet configured, enter user = administrator and password = password.
•
The Lynx Menu is to the far left. Under MCA Settings | Acq Setup, change
any acquisition parameters as needed from the options offered. Press Submit to
keep any changes made, or Reset to discard your changes here.
•
The Spectrum controls are to the right of the Menu. Near the top of this frame,
select the Spectrum tab, then select Start (under Acquire) to begin.
•
To Exit, click Logout in the upper left corner, or close your browser window.
This Quick-Start is over-simplified. Comprehensive options and settings are discussed
in the following chapters. Lynx user interface settings are covered in Chapter 4.
Note For future reference, fill in the URL for your Lynx system (if using a fixed
IP address) on the line above.
Navigating in this Manual
This manual is a reference to the capabilities and operation of the Lynx DSA. Each of
its chapters covers specific functions.
The Chapters are divided into the following arrangement:
1. Introduction
Starts with a Quick Start as a quick refresher for Users. A sample Energy
Calibration from the browser configuration - a commonly performed task - is
provided as an example of the Lynx interface and commands to introduce a new
user to its operation.
Key Features of the Lynx; an Overview of this guide; an FAQ section. Detailed
setup and User steps are addressed in other areas of the manual, and using the
online help.
2. Controls and Connectors
This chapter includes a brief description of each front panel LED indicator and
each rear panel connector.
3. System Configuration
This chapter includes instructions for setting up a typical system. This chapter
also reviews the interaction with the Genie 2000 Basic Spectroscopy software,
which is required for spectral analysis.
Chapter 1 - Introduction
2 Lynx™ Digital Signal Analyzer
To Next Page
Loading...