Setting Up a Modem Connection
Remote Access Services (RAS) is used to connect with Lynx via RS-232 modem,
which is used for your External Modem application.
Setting Up RAS for a Modem Connection
From your PC, Remote Access Services (RAS) is used to connect your PC to a Lynx
that is using a Modem, using an RS-232 connection.
Note If using a wired RS-232 connection (not using a modem), refer to the previ
-
ous section for instructions appropriate for a Serial connection, starting on
page 169.
Mode
The factory-default Mode setting (serial or modem) for RAS is Serial. This affects the
manner in which Windows will interact with Lynx for its setup. If you change that set
-
ting, your Windows steps may differ somewhat from the examples given.
Mode options include Serial, Modem, or None.
There is no 'default' operation available; RAS must be configured before this service
will be functional.
Default RAS Parameters for Lynx
Factory defaults set in Lynx are used to establish RAS connections in this section.
•
The default RAS User Account ID is: user
•
The default RAS Account password is: password
These Lynx settings may be changed at Lynx Menu | Network | RAS tab | Accounts
section, User Name and Password entries, discussed starting on page 103.
•
The default System Name for the Lynx, for RAS, is: Lynx
Lynx Name is found at: Lynx Menu | Setup | System | General | Name parameter,
discussed starting on page 123.
Windows RAS Settings for Modem
To use a modem with the RS-232 connection, you'll have to create a RAS Direct Se
-
rial Connection Phonebook entry on your Windows PC.
1.
On your Windows PC, right-click on the My Network Places desktop icon
and select Properties. You will see the Network Connections page. You
will create a new connection definition here.
Appendix B - Communications Setup
178 Lynx™ Digital Signal Analyzer
To Next Page
Loading...