SYSTEM COMPONENTS
•
Lynx Digital Signal Analyzer (Desktop).
•
AC-to-DC Adapter including removable IEC-type power cordset (cordset
included is North American NEMA 5-15P plug to IEC 320 female plug).
•
Operators manual (this document).
•
3 m (10 ft) 9-pin (DB9F to DB9M) serial interface cable.
•
3 m (10 ft) USB A-B cable.
•
3 m (10 ft) 10/100 BASE-TX UTP Ethernet cable (yellow in color).
•
3 m (10 ft) 10/100 BASE-TX UTP Ethernet Crossover cable (red in color, and
labeled near each connector as a 'crossover' cable).
Environmental
OPERATING TEMPERATURE RANGE – 0 to 50 °C.
HUMIDITY – Up to 80% non-condensing.
Ordering Information
LYNX Digital Signal Analyzer. If using Genie 2000 software (optional), requires Ge-
nie 2000 V3.1a or later.
LYNX-MOUNT KIT – Lynx-19 inch Rack Mount Kit; includes mounting hardware,
rack handles and a spacer to allow the physical mounting of one or two Lynx units, oc
-
cupying 2U in an equipment rack. One kit per each 2U application.
Programming Libraries
A separate Lynx Programming Libraries document is available. Ask your Canberra
representative for more information about the Programming Libraries.
Appendix A - Specifications
156 Lynx™ Digital Signal Analyzer
To Next Page
Loading...