Product Manual — Doc. 9045M DM NAX® • 5
❶
PWR: (1) LED, indicates operating power is supplied; illuminates amber while
booting, white when powered on, red when in standby (no audio or LAN
connection), and off when no power is supplied.
❷
LAN: (1) LED, illuminates white when the amplifier is connected to a network
with a valid IP address, and off when the device is not connected to a network or
the IP address is invalid.
❸
NAX: (1) LED, illuminates white when the AoIP is ready to pass and the unit's
PTP clock is synced, and off when there is no AoIP is passing to or from an
amplifier and/or PTP is not synced.
❹
SOURCE: (8) LEDs, illuminates white when a signal is detected on the specified
input/source, red when there is clipping on an analog input or bitstream audio
detected on a digital input, and off when there is no signal detected on the
specified input/source.
❺
ZONE: (8) LEDs, illuminates white when there is audio output on the indicated
zone, red when clipping or a fault is detected on the zone output due to
overcurrent, over temperature, or low voltage.
To Next Page
Loading...
Need help?
General
