Product Manual — Doc. 9045M DM NAX® • 7
Ethernet 2: (1) 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port;
Green LED indicates Ethernet link status;
Flashing amber LED indicates Ethernet activity
❽
SETUP: (1) Push button: Pressing and holding the SETUP button for 15 seconds with
power supplied clears network settings and restores the default DHCP mode;
Pressing and holding the SETUP button with power disconnected, then connecting
the power supply and continuing to hold SETUP button for 30 seconds performs a
factory restore;
(1) LED, illuminates red when the button is pressed, flashes red when reset has been
initiated
❾
CONSOLE: (1) Standard USB 2.0 Type B connector, female
❿
GROUND: 6-32 screw, chassis ground lug
⓫
10A Fuse: 10 A Fuse
⓬
POWER OUTLET: (1) 100-240V~50/60Hz Universal AC; IEC 60320 C14 Main power
inlet, mates with removable power cord (included)
To Next Page
Loading...
Need help?
General
