250 Hog 4 Operations Manual
13.2.4 Assigning Cue Timings in the Cuelist Window
You can edit fade or delay times in the Cuelist window. Assigning fade or delay times here
will assign the new value to all the parameters of all the fixtures in the cue.
1. Open + Choo se : open the cuelist of the desired master.
2. Click in the cell for the fade or delay time of the desired cue, and press Set.
3. Type in a time value, and press En ter.
When entering a time value, it should be in the form:
[ h o u r s ] h [ m in u t e s ] m [ s e c o n d s ] s / [ h o u r s ] h [ mi n u t e s ] m [ s e c o n d s ] s
For example:
2 s : 2 seconds in and out times.
2 s / 5 s : 2 seconds in, 5 seconds out.
1 m : 1 minute in and out times.
1 m1 0 s : 1 minute and 10 seconds in and out times.
1 h 1 0 m 3 0 s / 1 h : 1 hour, 10 minutes and 30 seconds in time, and 1 hour out time.
Use the H, M and S buttons that appear when editing a fade or delay time cell to enter the H,
M and S text into the cell. Alternatively, you can use an external keyboard.
Note that if you enter 1 4 0 the time will be 1 minute 40 seconds, not 140 seconds (2 minutes
20 seconds).
To Next Page
Loading...
