254 Hog 4 Operations Manual
13.3.2 Assign Parameter Timings with the Command Line
To assign the fade time for all parameters of a fixture:
1. Fixture 1 : select the fixtures you want to assign a time to, making sure that they have
been given parameter values.
2. Time 4 , Enter : assigns the fade time to 4 seconds.
To assign separate fade in and fade out times:
1. Fixture 1 : select the fixtures you want to assign a time to, making sure that they have
been given parameter values.
2. Time 4 / 7 , Enter : assigns the Fade In time to 4 seconds and the Fade Out time to 7
seconds.
To assign a fade time for a particular parameter type:
1. Fixture 1 : select the desired fixtures.
2. Co lour Time 4 , Enter : assigns the fade time of the colour parameters to 4 seconds.
To assign a delay time, press the Time key twice:
1. Fixture 1 : select the desired fixtures.
2. Time Time 2 , Enter : pressing Time twice assigns the delay time.
To assign a path, press the Time key three times:
1. Fixture 1 : select the desired fixtures.
2. Time Time Time 2 , Enter : enter a number to represent the path.
Select the path by entering a number; the mapping is the same as the order they appear on
the path toolbar, starting at zero for the default path.
To Next Page
Loading...
