24 Hog 4 Operations Manual
Naming a Desktop View
To name a desktop view using the View Toolbar:
1. Press the Set key together with the appropriate button on the View Toolbar. The
Quickname window will open.
2. Enter a name, and click on O K.
To name a desktop view using the Views Directory:
1. Open + View : opens the Vie ws Directory.
2. Select the button for the view you want to name. Make sure that the Guar d button is
depressed, otherwise you will activate the view instead of just selecting it.
3. Press the Set key. The Quickname window will open.
4. Enter a name, and click on O K.
Tip: You can also assign view names, and add comments to them, in the spreadsheet view
of the Views Directory. See Desktop View Options.
Recalling a Desktop View
You can recall desktop views in two ways:
With the View Toolbar: located at the top of the left hand screen. The views each
have their own button, and are loaded in pages of ten onto the toolbar. You can load the
next page by pressing the Next button at the right hand end of the toolbar, while Pig +
Next loads the previous page.
With the Views Directory window: press the view's button in the Views Directo ry
window. Make sure that the G ua rd button is not depressed, otherwise you will only
select the view, rather than activating it.
To Next Page
Loading...
