14. Effects 273
Once the effect table is assigned, you can modify the effect attributes either by editing the
values in the spreadsheet or using the parameter wheels when the Effect key is selected.
Tip: You can quickly edit the attributes of all one parameter type (All Intensity, All
Position, All Colour, All Beam) or for all parameters within the top five rows of the
Effects Engine.
To edit the values in the spreadsheet:
1. Select the cells for the parameters that you want to edit, and press Set.
2. Type a new value, and press En ter.
Or, using the parameter wheels:
1. Press the Effect key.
2. Select the individual parameters that you want to edit in the left hand Fun ction column
of the Effects Engine window.
3. Adjust the Size, Rate, Offset and Len gth parameter wheels as required.
Note that the parameter wheels only control the current effects row, selected using the
buttons in the Fun ction column. There are buttons for all parameter types, for all intensity,
all colour, all position, all beam, and for each individual parameter type.
Tip: All effect attributes can be fanned using the Fan key and parameter wheels; remember
to select the required parameter types in the Effects Engine Fu nction column first. You
can also enter a value of, say, 5 0 Thru 8 0 in a cell of the Effects En gine window. See
Fanning.
To Next Page
Loading...
