394 Hog 4 Operations Manual
21.4.4 Editing Timecode Values
To change the timecode value used to trigger a cue:
1. Open → Choose : open the Cuelist window.
2. Select the Wait cell for the cue, and press Se t.
3. From the toolbar, select Timecode.
4. Enter a timecode value in hours, minutes, seconds and frames, in the form
h h / m m/ s s . f f , then press En ter.
You may need to change the timecode value for one cue, and then change the timecode
values for subsequent cues by the same amount, to keep the same relative timings. For
example, you might have a series of cues where each one is triggered by timecode one
second after the previous one. If the timecode value triggering the first cue needs to be
increased by 12 frames, you may want the values for all the subsequent cues to also be
increased by 12 frames to maintain the 1 second separation. Hog 4 OS allows you to do this
easily:
1. Ope → Ch oose : open the Cuelist window.
2. Click and drag to select the Wa it cells for the range of cues you want to edit.
3. Press Set.
4. Edit the timecode value of the first cell then press Enter. All the selected timecode
values will be adjusted by the same amount of time added or subtracted from the first
value.
To Next Page
Loading...
