CHAPTER 6 KEYPAD
6-48
Test Operation Mode
6
(6) Alarm history initialization
The history of detected alarms recorded in the servo
amplifier is deleted. The alarm detection history (alarm
history) can be monitored with [
En02] in the maintenance
mode.
The alarm history is retained even after the power is turned off.
(7) Parameter initialization
Parameters are initialized.
After initializing parameters, be sure to turn the power off
then on again.
Go
Fn06
AL
in
SET
(1 sec. or over)
ESC
donE
End of initialization
ESC
SET
(1 sec. or over)
nG
SET
(1 sec. or over)
ESC
* For the cause of NG display, refer
to "NG display (common)" on page
6-43.
Go
Fn07
PA
in
ESC
SET
(1 sec. or over)
ESC
donE
SET
(1 sec. or over)
End of initialization
nG
SET
(1 sec. or over)
ESC
* For the cause of NG display, refer
to "NG display (common)" on page
6-43.
To Next Page
Loading...