CHAPTER 14 PC LOADER
14-44
Parameter Conversion Tool
14
■ When “Use the motor different from that before conversion” is selected.
When “Yes” is selected at gain system parameter conversion, the motor model after
conversion cannot be selected.
When “None” is selected at gain system parameter conversion, the motor model after
conversion can be selected.
■ When “Yes” at gain system parameter conversion and “Use the motor different from that
before conversion” are selected, with “GYG182BC2-T2*-*” or “GYG292BC2-T2*-*”
selected as “motor model before conversion”.
“17 bit” appears for the encoder after conversion, restricting change of encoder.
This is because the motors “GYG182BC2-T2*-*” and “GYG292BC2-T2*-*” are “17bit”
type only.
To Next Page
Loading...