103
4
Troubleshooting
4.7
Stapler Faults
This section describes how to remedy stapler faults. Follow the procedures on the following
pages when copies are not stapled or when staples are bent. Contact our Customer Support
Center if the problem persists after you have tried the following solutions.
To staple copies, the Light Finisher (option) must be installed, and 128 MB Memory kit must be installed.
If staples are stapled on the copies in the manner shown in the figures below, contact our
Customer Support Center.
Unstapled
Bent staple
One side of staple rising up
Staple bent in reverse direction
Flattened staple
Entire staple rising up
Staple rising up with center pressed in
To Next Page
Loading...
Need help?
General
