Loading Paper
28
2
2.1
Loading Paper
Following describes how to load paper in trays 1 to 4 and in tray 5 (Bypass Tray).
For details about paper that can be used on this machine, see the Paper Recommendations
for details on paper types suitable for copying and loadind in each tray. Use of inappropriate
paper may result in paper jams, cause reduced print quality, malfunctions and other trouble.
To make full and effect use of this machine’s performance, we recommend using only paper
recommended by Fuji Xerox.
If you want to use paper not recommended by Fuji Xerox, contact our Customer Support
Center.
2.1.1 Loading Paper in Trays 1 to 4
Following describes the procedure for loading paper in trays 1 to 4.
When the machine runs out of paper during copying or printing, a message is
displayed on the control panel display. Add paper according to the displayed
instructions. Copying or printing is automatically resumed when paper is added.
For details on changing the paper size and orientation, see “2.2 Changing the Size of Paper in Trays”
(P. 33).
Procedure
1
Pull out the tray towards you until it
stops.
2
Load and align the edge of the paper
against the left edge of the tray with the
side to be copied or printed on facing up.
Do not load paper exceeding the maximum fill line.
Doing so might cause paper jams or machine trouble.
When pulling out the paper tray, do it
slowly. If pulled out with too much
force, the tray can hit and injure your
knees.
MAX
Maximum Full Line
To Next Page
Loading...
Need help?
General
