Making Copies
288
2
2.4
Making Copies on Non-
standard Size Paper
This section describes how to make copies on non-standard size paper. When making cop-
ies on non-standard size paper, the size must be entered.
Procedure
1
Place the document on the document glass.
Place the document so that the top edge of the document is against the left side of the document glass.
For details about loading documents, see “1.2 Loading Documents” (P. 270).
2
Insert the paper into the tray with
the copy side facing down and its
top edge up against the paper feed
entrance.
When you load the paper, the Tray 5 (Bypass Tray)
screen is displayed on the display.
For details about loading paper in the Bypass Tray, see
“2.1.2 Loading Paper in Tray 5 (Bypass Tray)” (P. 30)
in “Part 1 Hardware”.
Do not load paper in the tray above the maximum fill
line.
3
Select Non-standard Size.
The area for entering the paper size is displayed.
When the Tray 5 (Bypass Tray) screen is not displayed, select More... at Paper Supply in the Basic
Copying screen, and then select Bypass Tray in the Paper Supply screen.
Tray 5 (Bypass)
SaveCancel
Auto Size
Detect
Standard
Size
Non-standard
Size
Paper Size
Paper Type
1/3
Bond
Plain
Lightweight (55-63g/m
2
)
Recycled
Transparency
Page
To Next Page
Loading...
Need help?
General
