5.4 Setting the System Settings (Common Settings)
138
5
System Administration Mode Settings
5.4.8 Initializing the Hard Disk (Diagnostics)
This feature initializes data on hard disk.
Initialize Hard Disk
This feature initializes data on hard disk.
Addon fonts, forms for HP-GL/2 and SMB folders are erased by initializing the hard disk.
Security print jobs and logs are not erased.
5.4.9 Migration to Sleep Mode and Offset Set-
tings (Others)
This section describes how to make other settings.
Others allows you to set the following items:
1. Sleep Mode
Set whether or not to move to the Sleep Mode.
When migration to the Sleep Mode is inhibited by this setting, timers at 8. Auto Power Saver (P. 124)
under “5.4.1 Machine Clock/Timers” cannot be set.
(Default is Enable.)
Migration to the Low Power mode cannot be inhibited.
●
For details about the Power Saver mode, see “1.3 Power Saver Mode” (P. 19).
●
For details about setting the migration to Sleep Mode timer, see 8. Auto Power Saver (P. 124) under
“5.4.1 Machine Clock/Timers”.
2. Job Offset (Center Output Tray)
Set Job Offset.
Printing with the position of prints shifted by job (individually instructed print job) or by set (copies)
is called “Offset”. If the output position of the previous job or set is towards you, then the next job or
set will be output shifted away from you. Set whether operation by this offset feature is by Offset Per
Set or Offset Per Job
(Default is Offset Per Set.)
3. Job Offset (Finisher Tray)
Set whether operation by this offset feature is by Offset Per Set or Offset Per Job when the Light Fin-
isher is installed.
(Default is Offset Per Set.)
●
1. Sleep Mode
●
2. Job Offset (Center Output Tray)
●
3. Job Offset (Finisher Tray)
To Next Page
Loading...
Need help?
General
