Loading Documents
270
1
1.2
Loading Documents
This section describes how to place documents on the document glass or load them on the DADF.
1.2.1 Placing Documents on the Document Glass
Following describes the procedure for placing documents on the document
glass.
Procedure
1
Open the document cover.
2
Place the document face down, and
align it against the inside left corner of
the document glass.
When placing transparencies, tracing paper or other
highly transparent documents, place a sheet of white
paper on top of the document.
3
Close the document cover.
When a standard-size document is loaded on the docu-
ment glass, the size of the document is displayed in the
message area.
●
When copying a thick document, do
not use excessive force to press it
against the document glass. The
glass may break and cause injuries.
●
If you make copies with the document
cover open, avoid looking directly at
the copy lamp. Direct eye exposure
can cause eye fatigue or damage.
To Next Page
Loading...
Need help?
General
