7.2 Confirming Jobs
262
7
Confirming Jobs
7.2.8 Forcibly Outputting Data Wait Docu-
ments
Following describes how to forcibly output documents in the printer that are wait-
ing for data.
In the emulation mode, documents cannot be printed out until an entire page’s
worth of data has been received. When the data ends halfway through the page,
the machine stands by for the next data until the time set at “Auto Eject Time”
has elapsed.
When there is a document waiting for data in the printer like this, the following
message is displayed on the display. Remedy this by following the procedure
described below.
The auto output time can be set only in the System Administration Mode. For details on how to set this
time, see Parallel “Auto Eject Time” (P. 159) in “5.6.1 Port Settings”. The default setting is 30 sec-
onds.
Procedure
1
Select End Data in the screen that is displayed.
This ends data reception, and forcibly outputs the job.
Select the Close button, then the screen returns to its previous state.
Close
Data Wait
There is a print job waiting for data.
Select End Data if you want to stop receiving data
and print the job now.
End Data
To Next Page
Loading...
Need help?
General
