Fuji Xerox DocumentCentre C400 Series User Manual

117
5
System Administration Mode Settings
5.3
Setting and Changing System
Administrator’s Passwords
This section describes how to set and change passwords for entering the System Adminis-
tration Mode.
The default System Administrator’s password is set to “11111”. When a password is set, you
can no longer enter the System Administration Mode unless that password No. is entered
again.
When a password is set, you can also output meter reports and a list of registered mail-
boxes in the System Administration Mode.
A System Administrator’s password must be set to prevent unintentional changes to settings
and ensure security.
When a password is not set, passwords can no longer be applied to mailboxes and other items.
5.3.1 Setting New Passwords
The following describes the procedure for setting a new password from a state
where the System Administrator’s password has not been set. The default Sys-
tem Administrator’s password is set to “11111”. You can set any 4- to 12-digit
number as a password.
Procedure
1
Press Password/System Settings.
The System Settings screen is displayed.
2
Select System Administrator Password.
The System Administrator Password screen is displayed.
Close
System Settings
System Settings
Auditron
Administration
Setup Menu System Administrator
Password

Fuji Xerox DocumentCentre C400 Series Specifications

General

Brand	Fuji Xerox
Model	DocumentCentre C400 Series
Category	Copier
Language	English