Fuji Xerox DocumentCentre C400 Series User Manual

5.7 Print Mode Settings
167
5
System Administration Mode Settings
5.7.1 Allocate Memory
Allocate Memory involves setting the size of receive buffer memory (where data
sent from the client is temporarily stored) for each interface.
Allocate Memory allows you to set the following items:
With LPD, SMB and IPP, set whether or not to spool to memory, where to spool
to when spooling is enabled, and the assigned memory size when spooling to
memory (LPD and SMB only).
The size of the receive buffer can be changed according to the current state of
use and your particular requirements. If the receive buffer size is increased, cli-
ents supporting each of the respective interfaces are sometimes resolved more
quickly. The maximum value that can be set changes according to the amount of
remaining free memory.
●
When the memory size is changed, memory is reset, and all data currently stored in each memory
area is erased.
●
Memory assignments exceeding the total memory size are not possible. If the setting values exceed
the size of mounted memory when the power is turned on, the values are automatically adjusted by
the system. For details about memory assignments, see “1.5 Memory Allocation” in “Part 1
Printer” of the User Guide (Printer/Scanner).
●
When the port is set to Disabled, each of the corresponding items is not displayed.
●
Depending on the amount of data sent from the client, the client resolution time sometimes does not
change even if memory is increased.
PCL5e Memory
Specify the size of memory used by PCL5e.
Set any size within the range 2.50 to 32.00MB in 0.25MB increments.
(Default is 5.00 MB.)
PostScript Memory
Specify the size of memory used by PostScript. This item is displayed when the PostScript
®
Soft-
ware Kit is installed.
Set any size within the range 8.00 to 32.00 MB in 0.25 MB increments.
The maximum value that can be set changes according to the amount of remaining free memory.
(Default is 16.00 MB.)
●
1. PCL5e Memory
●
6. Receiving Buffer - NetWare
●
2. PostScript Memory
●
7. Receiving Buffer - SMB Spool
●
3. HP-GL/2 Auto Layout Memory
●
8. Receiving Buffer - IPP Spool
●
4. Receiving Buffer - Parallel
●
9. Receiving Buffer - EtherTalk
●
5. Receiving Buffer - LPD Spool
●
10. Receiving Buffer - Port 9100

Fuji Xerox DocumentCentre C400 Series Specifications

General

Brand	Fuji Xerox
Model	DocumentCentre C400 Series
Category	Copier
Language	English