Fuji Xerox DocumentCentre C400 Series User Manual

324
3
User Friendly Features
Basic Copying Added Features Image Quality Others
3.6
Sorting Copies Before Out-
put - Output
You can select from the following three ways of outputting copies. When the Offset Catch
Tray (option) is installed, copies are output the output position alternately shifted to distin-
guish each copy job.
●
Auto
Copies are output collated when the document feeder, Book Duplex, Covers, Separators + N Sets or No Separators
+ N Sets under Transparency Separators, Booklet, and Stapling are set.
●
Collated
The specified number of copies are output sorted in page order.
●
Uncollated
The specified number of copies are output not sorted in page order.
●
The default setting for Output/Stapling can be changed in the System Administration Mode. For details about how
to change the default for this feature, see “5.5 Copy Mode Settings” (P. 139) in “Part 1 Hardware”. The default
setting is Auto.
●
To use the Output feature, the 128 MB Memory Kit must be installed.
●
Uncollated cannot be selected when Booklet, Covers, Stapling, Separators + N Sets or No Separators + N Sets
under Transparency Separators, Book Duplex, and Build Job features are selected.
●
Collated cannot be selected when the Repeat Image and Poster features are selected.
Procedure
1
Load the document.
For details about loading documents, see “1.2 Loading Documents” (P. 270).
3
Document
3
A
B
2
Report
1
3
A
B
2
Report
1
3
A
B
2
Report
1
Collated
Uncollated
3
A
B
2
A
B
2
Report
1
Report
1

Fuji Xerox DocumentCentre C400 Series Specifications

General

Brand	Fuji Xerox
Model	DocumentCentre C400 Series
Category	Copier
Language	English