5.4 Setting the System Settings (Common Settings)
125
5
System Administration Mode Settings
5.4.2 Setting Audio Tones
Set whether or not to sound tones, for example, at completion of a job or when a
machine fault occurs.
Audio Tones allows you to set the following items:
1. Control Panel Select Tone
Set the tone to sound when a button displayed on the display is normally selected. You can select Off
to not sound a tone, or select one of Loud, Normal or Soft as the volume.
(Default is Normal.)
2. Control Panel Alert Tone
Set the tone to sound when an inoperable button is selected or a button is selected when an error has
occurred. You can select Off to not sound a tone, or select one of Loud, Normal or Soft as the vol-
ume.
(Default is Normal.)
3. Machine Ready Tone
Set the tone to sound when the machine is ready to copy or print, for example, after the power is
turned on. You can select Off to not sound a tone, or select one of Loud, Normal or Soft as the vol-
ume.
(Default is Normal.)
4. Copy Job Complete Tone
Set the tone to sound when copying has ended successfully. You can select Off to not sound a tone,
or select one of Loud, Normal or Soft as the volume.
(Default is Normal.)
5. Non-Copy Job Complete Tone
Set the tone to sound when a job other than copying has ended successfully. You can select Off to not
sound a tone, or select one of Loud, Normal or Soft as the volume.
(Default is Normal.)
6. Alert Tone
Set whether or not to sound a tone when a job has ended abnormally. You can select Off to not sound
a tone, or select one of Loud, Normal or Soft as the volume. (Default is Normal.)
●
1. Control Panel Select Tone
●
5. Non-Copy Job Complete Tone
●
2. Control Panel Alert Tone
●
6. Alert Tone
●
3. Machine Ready Tone
●
7. Fault Tone
●
4. Copy Job Complete Tone
●
8. Low Toner Alert Tone
To Next Page
Loading...
Need help?
General
