Fuji Xerox DocumentCentre C400 Series User Manual

5.6 Network Settings
160
5
System Administration Mode Settings
LPD
Set the following items when using LPD:
■Port Status
Set whether to Enabled or Disabled the Port Status when the power is turned on.
When LPD is used, set to Enabled.
(Default is Enabled.)
When the Port Status is set to Enabled, the port status is sometimes automatically set to Disabled if there is
insufficient memory. If this happens, either set the status of the unused port to Disabled, or change the assigned
memory size.
The IP address must be set to start the LPD port.
NetWare
Set the following items when using NetWare.
■Port Status
Set whether to Enabled or Disabled the NetWare port status when the power is turned on. When Net-
Ware is used, set to Enabled.
(Default is Disabled.)
When the port status is set to Enabled, the port status is sometimes automatically set to Disabled if there is insuf-
ficient memory. If this happens, either set the status of the unused port to Disabled, or change the assigned mem-
ory size.

Fuji Xerox DocumentCentre C400 Series Specifications

General

Brand	Fuji Xerox
Model	DocumentCentre C400 Series
Category	Copier
Language	English