E Error Codes Displayed on the Display
451
Appendix
116-702
“Cause” Printing was performed using a substitute font.
“Remedy” Check the print data.
116-703
“Cause” An error occurred during PostScript (option) processing.
“Remedy” Either confirm the print data, or click [Spool Settings] on the [Details]
tab in the printer driver to set bi-directional communications off.
116-710
“Cause” A probable cause is that the correct document size could not be
judged as the receive data exceeded the HP-GL/2 (option) spool size.
“Remedy” Increase the size assigned to HP-GL/2 auto-layout memory.
116-714
“Cause” An HP-GL/2 (option) command error occurred.
“Remedy” Check the print data.
116-740
“Cause” A numerical value operation error occurred as a value exceeding the
value limit of the printer was used in the print data.
“Remedy” Check the print data.
116-747
“Cause” There are too many paper margin values for the HP-GL/2 (option)
effective coordinate area.
“Remedy” Reduce the paper margin values, and instruct printing again.
116-748
“Cause” There is no plot data in the HP-GL/2 (option) print data.
“Remedy” Check the print data.
116-780
“Cause” There is a problem with the document attached to the received mail.
“Remedy” Check the attached document.
Error Code Cause/Remedy
To Next Page
Loading...