3.3 Cleaning the Copier
64
3
Daily Care
3
Holding the center section of the toner
collection bottle pull the bottle out until it
comes to a stop.
To prevent the toner collection bottle from tilting and
spilling toner, place the bottle at another location away
from the machine. Lay paper on the floor and place the
toner collection bottle on top of that paper.
4
Remove the cleaning rod (provided)
from the rear of the front door. Gently
insert the cleaning rod into cleaning
slots D1 to D4 (square holes) with the
pad facing down.
5
When the cleaning rod has gone in as
far as possible, gently draw it out
towards you. Clean each of the four
locations.
It is almost impossible to see dirt on the pad.
6
Push in the toner collection bottle that
you removed as far as possible making
sure that its center section is properly
aligned.
To Next Page
Loading...
Need help?
General
