Introduction
3. Terms and Symbols
Preface-3
3. Terms and Symbols
This section describes the terms and symbols used throughout this manual.
The terms and symbols used at the beginning of a text
are defined as follows:
• REP : Indicates the disassembly/assembly procedure for reference.
• A
DJ : Indicates the adjustment procedure for reference.
• PL : Indicates the parts list for reference.
• ASSY : Means Assembly.
Safety Critical Components (SCC)
Control of the safety of components that are desig
nate
d Safety Critical Components shall conform
to Fuji Xerox Co. Ltd-stipulated rules and regulations on Safety Critical Components.
As to replacement of any component designated SCC, the complete comp
onent unit must be
replaced. It must never be disassembled or no individual internal parts of it must be replaced.
Installation of any part other than the ones designated by
Fuji Xerox Co. Ltd. shall be strictly
prohibited because it cannot be guaranteed in quality and safety.
Important Information Stored Component (ISC)
Important Information Stored Components store customers’ important information they have
enter
ed
after machine installation. When replacing Important Information Stored Components, you
must replace and discard them, following the procedure described in Chapter 4 Adjustments. Take
care never to let customer information leak out.
Indicates an imminently hazardous situation, such as death or serious injury if
operators do not handle the machine correctly by disregarding the statement.
DANGER
Indicates a potentially hazardous situation, such as death or serious injury if
operators do not handle the machine correctly by disregarding the statement.
Indicates a potentially hazardous situation, such as injury or property damage
if operators do not handle the machine correctly by disregarding the statement.
Used to emphasize the procedure, servicing, and regulation.
NOTE
To Next Page
Loading...
Need help?
General
