Chapter 2 Troubleshooting
2.1 Preface
2-2
2.1.2 Check Installation Status
Before starting to troubleshoot, always check the following items.
1 The voltage of the Power Supply is within the specification.
(Measure the voltage at the electrical outlet.)
2 Check the power cord for damage, short circuit, open circuit, bare wire, and improper connection.
3 The machine for proper grounding.
4 The machine is not installed in a place with high temperature, high humidity, low temperature,
low humidity, or a place with drastic changes in temperature.
5 The machine is not installed near a water outlet, humidifier, heater or fire, dusty areas, or under
the direct draft of an air-conditioner.
6 The machine is not installed in a place where volatile or flammable gas is generated.
7 The machine is not installed in a place exposed to direct sunlight.
8 The machine is installed in a well-ventilated place.
9 The machine is installed on a stable level surface.
10 The paper is within the specification. (Standard paper is recommended.)
11 The machine for any improper handling.
12 The Periodic Replacement Parts are replaced at every replacement sheet count.
To Next Page
Loading...
Need help?
General
