Chapter 6 General
6.9 Print Function Test (Test Print)
6-64
6.9 Print Function Test (Test Print)
You can perform a test print using a specified pattern. If a paper jam occurs or the paper runs out during print-
ing, perform the appropriate recovery action and wait until the error is cleared.
Do not remove the cassette while the test is being executed. Otherwise, printing is interrupted.
Before the print test, check that the paper tray contains enough paper.
6.9.1 Procedure for the Print Function Test
This section describes how to perform a test print using the gradation pattern as an example.
1 Enter the CE mode. (See "6.4.2 How to Enter the CE Mode".)
2 Confirm that [Printer Diag] is selected, and then press the [OK] button.
3 Use the [T] button to select [Test Print], and then press the [OK] button.
4 Use the [T] button to select [Gradation], and then press the [OK] button.
5 Press the [OK] button to print the test pattern.
• The screen returns to [Ready to print] after printing.
6 Press the [C(Clear)] button to return to the [Printer Diag] screen.
7 Exits the CE mode. (See "6.4.4 How to Exit the CE Mode".)
Printer Diag
Test Print
Test Print
Pattern IOT
Test Print
Gradation
Gradation
Ready to print
Gradation
Processing
Gradation
Ready to print
To Next Page
Loading...
Need help?
General
