Chapter 4 Disassembly / Assembly and Adjustment
4.1 Preface
4-1
4.1 Preface
Parts removal and replacement procedures are described in the following categories as classified in the parts
list.
REP1 UI
REP2 ROS
REP3 Drive
REP5 Dispenser
REP6 Transfer
REP7 Fusing
REP8 Xerographics
REP9 Tray
REP10 Option Tray
REP13 MSI
REP14 Duplex
REP15 Registration
REP17 Exit
REP18 Electrical
REP19 Cover
REP21 DADF / IIT
When working on a part which is controlled as a spare but for which no procedure is provided, observe care-
fully how it is attached before removing it.
As a general rule, optional items are assumed to have been removed from the equipment. However, you may
work with optional items attached if they do not disturb your work.
The parts which <SCC>, <ISC> are written before procedure items [REP X.Y "AAAAA"] are Safety Critical
Component or Important Information Stored Component.
SCC：Safety Critical Component
For the safety control of the Safety Critical Components and the components specified, follow the regu-
lations regarding the Safety Critical Components set by Fuji Xerox Co., Ltd.
As to replacement of any component designated SCC, the complete component unit must be replaced.
It must never be disassembled or no individual internal parts of it must be replaced.
Installation of any part other than the ones designated by Fuji Xerox Co. Ltd. shall be strictly prohibited
because it cannot be guaranteed in quality and safety.
ISC：Important Information Stored Component
This component stores all the important customer information that is input after the installation. When
performing replacement, follow the procedures in ’Chapter 4 Adjustment’ to replace/discard. Make
absolutely sure that no customer information gets leaked outside.
To Next Page
Loading...
Need help?
General
