Chapter 6 General
6.6 IOT Diag
6-54
6.6.4 ROS Exposure
Corrects the variation in the Lead-Regi of the ROS.
Procedure
1 Enter the CE mode. (See "6.4.2 How to Enter the CE Mode".)
2 Confirm that [Printer Diag] is selected, and then press the [OK] button.
3 Use the [T] button to select [IOT Diag], and then press the [OK] button.
4 Use the [T] button to select [ROS Exposure], and then press the [OK] button.
5 Press the [OK] button.
6 Press the [OK] button.
7 Press the [C(Clear)] button to return to the [Printer Diag] screen.
8 Exits the CE mode. (See "6.4.4 How to Exit the CE Mode".)
Printer Diag
IOT Diag
IOT Diag
Digital Input
IOT Diag
ROS Exposure
ROS Exposure
Auto Correct
Auto Correct
Processing
Auto Correct
Corrected
To Next Page
Loading...
Need help?
General
