Fujitsu PRIMERGY TX2550 M4 - Removing the Anti-Tilt Bracket

TX2550 M4 Upgrade and Maintenance Manual 103
Basic hardware procedures
Figure 58: Installing the anti-tilt bracket (B)
Ê Secure the anti-tilt bracket on the rear of the server with two knurled thumb
screws.
4.13.2 Removing the anti-tilt bracket
Ê Loosen the two knurled thumb screws on the anti-tilt bracket (see figure 58).
Ê Remove the anti-tilt bracket from the rear of the server.