Fujitsu PRIMERGY TX2550 M4 - Installing HDD Modules into the 8 X 2.5-Inch HDD;SSD Extension Box; Concluding Steps; Removing the 8 X 2.5-Inch HDD;SSD Extension Box; Preliminary Steps

246 Upgrade and Maintenance Manual TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
7.5.2.6 Installing HDD modules into the 8x 2.5-inch HDD/SSD extension
box
Ê "Reassembling" on page 68
Ê Install HDD modules or HDD dummy modules into the additional HDD bays,
see sections "Installing a 2.5-inch HDD/SSD module" on page 180 and
"Installing a 2.5-inch HDD/SSD dummy module" on page 183.
I For more information on HDD mounting order, see section "2.5-inch
HDD/SSD configurations" on page 166.
7.5.2.7 Concluding steps
Ê Install the fan bridge, see section "Handling fan bridges" on page 90
Ê "Installing the system air duct" on page 68
Ê "Reassembling" on page 68
Ê "Connecting the power cord" on page 81
Ê "Resuming BitLocker functionality" on page 127
Ê "Switching on the server" on page 82
7.5.3 Removing the 8x 2.5-inch HDD/SSD extension box
7.5.3.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 105
Ê "Shutting down the server" on page 52
Ê "Disconnecting the power cord" on page 53
Ê Remove all HDD modules from the HDD/SSD extension box, see section
"Removing 2.5-inch HDD/SSD modules" on page 181.
Ê "Getting access to the component" on page 54
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less