438 Upgrade and Maintenance Manual TX2550 M4
System board and components
14.5.3.1 Preliminary steps
Ê "Shutting down the server" on page 52
Ê "Disconnecting the power cord" on page 53
Ê "Getting access to the component" on page 54
Ê "Removing the system air duct" on page 67
Ê "Removing the PCI air duct" on page 86
Ê If applicable, "Removing the riser module" on page 84
Ê "Removing the crossbar" on page 88
Ê If applicable, "Removing an expansion card" on page 318
14.5.3.2 Replacing the M.2 SSD
Ê Remove the defective M.2 SSD, see section "Removing the M.2 SSD" on
page 436.
Ê Install the new M.2 SSD, see section "Installing an M.2 SSD" on page 432.
14.5.3.3 Concluding steps
Ê If applicable, "Installing an expansion card" on page 312
Ê "Installing the crossbar" on page 89
Ê If applicable, "Installing the riser module" on page 85
Ê "Installing the PCI air duct" on page 87
Ê "Installing the system air duct" on page 68
Ê "Reassembling" on page 68
Ê "Connecting the power cord" on page 81
Ê "Switching on the server" on page 82
14.5.3.4 Software configuration
I To install the ESXi to the M.2 SSD, see section "Software configuration"
on page 435.
To Next Page
Loading...
