70 Upgrade and Maintenance Manual TX2550 M4
Basic hardware procedures
Figure 21: Installing the rack front cover (B)
Ê Secure the rack front cover to the chassis with two screws on either side.
Ê Insert and push the ID card into its slot until it locks in place as shown (see
figure 7 on page 59).
4.5.2.2 Installing the top cover
I Note for servers with the configuration up to 32x 2.5" HDD/SSD modules:
For this configuration the locking lever is positioned more in the middle.
It is not possible to use this top cover in other configurations.
To Next Page
Loading...
