EasyManua.ls Logo

Fujitsu PRIMERGY TX2550 M4 - Replacing the Dual Microsd 64 GB Enterprise

Fujitsu PRIMERGY TX2550 M4
563 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX2550 M4 Upgrade and Maintenance Manual 447
System board and components
Ê "Disconnecting the power cord" on page 53
Ê "Getting access to the component" on page 54
14.6.3.2 Replacing the Dual microSD 64GB Enterprise
Ê Remove the defective Dual microSD 64GB Enterprise, see section
"Removing the Dual microSD 64GB Enterprise" on page 444.
Ê Remove both microSD cards from the defective Dual microSD 64GB
Enterprise. Proceed as described in the following:
Figure 323: Removing the microSD card
Ê To eject the microSD card, gently push it in and then let go (1).
Ê Pull the microSD card straight out of its slot (2).
Ê Install both microSD cards on the new Dual microSD 64GB Enterprise.
Proceed as described in the following:
Figure 324: Installing the microSD card
Ê With the label facing up, insert the microSD card into the microSD slot on
the controller (1) until it locks in place (2).
Ê Install the new Dual microSD 64GB Enterprise, see section "Installing the
Dual microSD 64GB Enterprise" on page 439.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX2550 M4

Related product manuals