Fujitsu PRIMERGY TX2550 M4 - Installing a PSU; Preliminary Steps; Removing the Dummy Cover

140 Upgrade and Maintenance Manual TX2550 M4
Power supply unit (PSU)
6.2.1 Installing a PSU
6.2.1.1 Preliminary steps
No steps needed.
6.2.1.2 Removing the dummy cover
Figure 62: Removing the PSU dummy cover
Ê Press in on both release latches (1) and remove the dummy cover (2).
V CAUTION!
Keep the dummy cover for future use. If a PSU is removed and not
immediately replaced by a new one, a dummy cover must be reinstalled
in the bay to comply with applicable EMC regulations and satisfy cooling
requirements.
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less