TX2550 M4 Upgrade and Maintenance Manual 131
Basic software procedures
Note on Advanced Thermal Design (ATD)
I If the Advanced Thermal Design (ATD) option is available and has been
enabled for your server, please set information within the Chassis ID
Prom Tool accordingly.
The ATD option can only be ordered from the manufacturer as a factory
preset. To find out if your server is ATD-enabled, check for the ATD logo
on the identification rating plate.
For ATD logo and more information on Advanced Thermal Design (ATD),
see the operating manual of your server.
V CAUTION!
Please note that you can only set the ATD flag. Resetting the ATD flag
using the Chassis ID Prom Tool is not possible!
5.2.18 Configuring LAN teaming
Use ServerView Operations Manager to obtain more information on existing
LAN teams:
Ê In ServerView Operations Manager Single System View select System Status
from the Information/Operation menu.
Ê Under Network Interfaces select LAN Teaming.
Ê The Network Interfaces (Summary) overview shows all configured LAN teams
and their components. Choose a LAN team to display further details:
– LAN Team Properties: Properties of the selected LAN team
– LAN Team Statistics: Available statistics about the selected LAN team
I For more information, see the "ServerView Operations Manager - Server
Management" user guide.
5.2.18.1 After replacing/upgrading LAN controllers
Ê You need to restore the configuration for the LAN Teaming, using the LAN
driver utility or OS teaming software.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I For more information, see the relevant LAN driver manual.
To Next Page
Loading...
