Fujitsu PRIMERGY TX2550 M4 - Removing the Ultraslim ODD

TX2550 M4 Upgrade and Maintenance Manual 401
Accessible drives
12.6.2 Removing the ultraslim ODD
12.6.2.1 Preliminary steps
Ê "Removing backup and optical disk media" on page 108
Ê "Shutting down the server" on page 52
Ê "Disconnecting the power cord" on page 53
Ê "Getting access to the component" on page 54
I The front cover only needs to be removed in order to remove or install
accessible drive dummy covers.
Ê "Removing the system air duct" on page 67
Ê If applicable, "Removing the riser module" on page 84
Ê If applicable, remove the expansion card, see section "Removing an
expansion card" on page 318.
Ê Remove the fan bridge, see section "Handling fan bridges" on page 90.
Ê If applicable, "Removing the 4x 3.5-inch HDD extension box" on page 255
12.6.2.2 Removing the ultraslim ODD adapter
Ê Remove the ultraslim ODD adapter, see section "Removing an accessible
drive" on page 386.
12.6.2.3 Removing the ultraslim ODD from the ultraslim ODD adapter
Ê Disconnect the power cable and the SATA cable from the ultraslim ODD (see
figure 283).
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH0 / (+) No. 0 screw driver