Fujitsu PRIMERGY TX2550 M4 - Preliminary Steps; Removing the Defective 3.5-Inch HDD Module; Installing the New 3.5-Inch HDD Module; Concluding Steps

224 Upgrade and Maintenance Manual TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
7.4.8.1 Preliminary steps
Ê "Locating the defective server" on page 49
Ê When working on a floorstand model, open the HDD bay cover, see section
"Removing the drive covers" on page 64.
Ê "Locating the defective component" on page 51
7.4.8.2 Removing the defective 3.5-inch HDD module
Ê Remove the HDD module, see section "Removing a 3.5-inch HDD module"
on page 221.
Ê If applicable, remove the HDD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 160.
7.4.8.3 Installing the new 3.5-inch HDD module
Ê If applicable, install the HDD in the installation frame, see section "Handling
HDDs or SSDs without installation frame" on page 160.
Ê Install the HDD module, see section "Installing 3.5-inch HDD modules" on
page 218.
7.4.8.4 Concluding steps
Ê When working on a floorstand model, close the HDD bay cover, see section
"Installing the drive covers" on page 76.
Ê "Performing a RAID array rebuild" on page 128