274 Upgrade and Maintenance Manual TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
Figure 185: Connecting cables to the non-hot-plug HDDs/SSDs
Ê Connect the cable C35:
– data/power connector (P2) from the non-hot-plug HDD/SSD 1 (1)
– To the connector X18 on backplane 1 (2)
– To the connector X10 on the SAS expander board (3)
– If applicable, data/power connector (P3) to non-hot-plug HDD/SSD 2 (4)
– If applicable, power connector to backplane 2 connector X18 (5)
I For the cable plan see chapter "Appendix B" on page 517.
7.7.2.3 Concluding steps
Ê Install the fan bridge, see section "Handling fan bridges" on page 90
Ê "Installing the system air duct" on page 68
Ê "Reassembling" on page 68
Ê "Connecting the power cord" on page 81
To Next Page
Loading...
